Articles in this category H685 4G Quick Start Guide This page contains basic information and guidance on the hardware and configuration for the Proroute H685 4G WRT router. More detailed instructions can be found in the quick start video and user manua... H685 4G User Manual To view the User Manual PDF version 1.0 it is available here Configure APN settings In order for the router to make an internet connection to a mobile network, the correct APN settings for the SIM are required in the router. If you are using a standard SIM (non-fixed public IP) the ... ICMP Check (Ping Reboot) ICMP Check (also know as Ping Reboot) this is very useful service which is recommended in most remote router installations, specially in unmanned locations. Set up Port Forwarding Port forwarding allows you to connect to your devices which are connected to the router's LAN, when you are connecting from the internet. In order to connect to the router over the internet it will n... Restore Router to Default Factory Settings (Factory Reset) Performing a factory reset on the router is a reliable way to clear any problematic configurations in the router, and is one of the best tools for troubleshooting and fixing issues. Terminal block Information and Installation As standard the H685 router comes with a terminal block, this will be pre-installed already connected to the body of the router and does not need to be altered. H685 - LED Lights Information H685 LED Light order Antenna Information and Installation This article contains information about the antennas for the H685, including the standard antennas shipped with the router and installing external antennas. Set WiFi to Client AP for internet access (WiFi WWAN) This article shows how to set up the Proroute H685 4G to get internet access, through WIfi from another WiFi network. The H685 4G uses B/G/N Wi-fi 2.4GHz, it can connect to these Wi-Fi network standar... Firmware upgrade To keep your router up to date with the latest functions and security features, upgrade to the latest Firmware Level. Change WAN port to be second LAN port To change the WAN port to be a LAN port, go to Network > Operation Mode. Tick box 'Wired WAN acts as LAN', then save and apply.